Stop losing the 10mm.

Stick it on the fender. Your sockets, bolts and screws stay right where you put them.

Shop the mat

Dropped it again?

It rolls off the fender, falls into the engine bay, and you're climbing out to go find it. Again. Veltro keeps every part right where you put it.

  • 1. Lay it down

    Put it on the fender, the toolbox or the bench. The magnets hold it to steel.

  • 2. Drop your parts

    Bolts, sockets and screws stay where you put them. Nothing rolls off.

  • 3. Keep working

    Your parts are right there when you need them. No climbing out to go find them.

    Veltro vs. the usual fixes

    The magnetic bowl and the shop rag both do one job. The mat does both.

      Magnetic bowl Shop rag
    Fits curves
    Holds parts
    Parts in view
    Works upright
    Packs flat

    Questions

    What does it stick to?

    Steel. Fenders, hoods, toolboxes, lifts and jack stands. It won't hold to aluminum, plastic or fiberglass panels.

    What will it hold?

    Small steel parts: screws, nuts, bolts, washers, sockets and wrenches. Stainless and aluminum parts won't stick, because they aren't magnetic.

    How big are the mats?

    Large: [VERIFY]. Long strip: [VERIFY]. Small square: [VERIFY].

    Will it scratch my paint?

    The top is soft rubber and the edge is stitched fabric. Wipe the panel and the bottom of the mat first. Grit trapped under anything can mark paint.

    Can it go near a hot engine?

    Keep it off exhaust parts and hot manifolds. High heat can weaken magnets.